Toyota Venza: Front Brake

Brake (front)

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Check Mode Procedure
CHECK MODE PROCEDURE 1. CHECK MODE (SIGNAL CHECK): DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / SRS Ai ...

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH (a) Temporarily install the rear No. 1 suspension arm assembly LH to the rear suspension member with the bolt (B). Text in Illustration ...

Installation
INSTALLATION PROCEDURE 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (a) Pass the hood lock control cable assembly into the engine compartment. (b) Pass the cable through the upper radiator support. (c) Engage the each clamp shown in the illustration. 2. I ...