Toyota Venza: Wireless Door Lock Control System(w/o Smart Key System)
- Precaution
- Parts Location
- System Description
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Registration
- Problem Symptoms Table
- Diagnosis System
- Terminals Of Ecu
- Data List / Active Test
- Dtc Check / Clear
- Diagnostic Trouble Code Chart
- Wireless Door Lock Tuner Circuit Malfunction (B1242)
- Only Wireless Control Function is Inoperative
No Answer-Back
DESCRIPTION
In some cases, wireless door lock control functions are normal but the hazard
warning light and/or wireless door lock buzzer answer-back function(s) does not
operate. In such cases, t ...
Precaution
PRECAUTION
1. PRECAUTION FOR DISCONNECTING THE BATTERY CABLE
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize
the following systems after the terminal is re ...
Other materials about Toyota Venza:
Startability Malfunction (P1604)
DESCRIPTION
This DTC is stored when the engine does not start even though the STA signal
is input or when the engine takes a long time to start, and when the engine speed
is low or the engine stalls just after the engine starts.
Using the Techstream, the ...
Power Source Mode does not Change to ON (ACC)
DESCRIPTION
When the engine switch is pushed with the electrical key in the cabin, the power
management control ECU receives signals to change the power source mode.
HINT:
To allow use of the Techstream to inspect the push-button start function when
the ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL DRIVE MONITOR SWITCH
(a) Engage the 4 claws to install the drive monitor switch.
2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display
Type)
3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH B ...
0.1266