Toyota Venza: Wiper / Washer

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 2 WINDSHIELD GLASS STOPPER (a) Using a brush or a sponge, coat the application area of 2 new No. 2 windshield glass stoppers with Primer G. NOTICE: ...

Front Wiper Motor

...

Other materials about Toyota Venza:

Vehicle Speed Signal Error (Test Mode DTC) (C2191/91)
DESCRIPTION The tire pressure warning ECU receives a vehicle speed signal from the combination meter. This DTC is stored upon entering signal check mode (test mode), and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE PROPELLER WITH ...

Engine does not Start
DESCRIPTION 1. ENGINE START SYSTEM FUNCTION (a) If the engine switch is pressed with the shift lever in P or N and the brake pedal depressed, the power management control ECU determines that this is an engine start request. (b) The certification ECU (sm ...