Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

Toyota Venza Service Manual / U660e Automatic Transmission / Transaxle / Automatic Transaxle System / Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

  • If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the "See page" given.
  • If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Trouble Area" column of the table.
  • *1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates.
  • *2: "DTC stored" means the TCM memorizes the trouble code if the TCM detects the DTC detection condition.
  • These DTCs may be output when clutches, brakes, gear components, etc., inside the automatic transaxle are damaged.
Automatic Transaxle System

DTC Code

Detection Item

Trouble Area

MIL*1

Memory*2

See page

P0500

Vehicle Speed Sensor "A"

1. Open or short in vehicle speed signal circuit

2. Combination meter

3. Vehicle speed sensor (Brake control system)

4. Skid control ECU (Brake control system)

5. TCM

Comes on

DTC stored


P0560

System Voltage

1. Open in back-up power source circuit

2. SFI system

3. TCM

Comes on

DTC stored


P0617

Starter Relay Circuit High

1. Park/neutral position switch

2. Starter relay circuit

3. Cranking holding function circuit

4. TCM

Comes on

DTC stored


P062F

Internal Control Module EEPROM Error

TCM

Comes on

DTC stored


P0705

Transmission Range Sensor Circuit Malfunction (PRNDL Input)

1. Open or short in park/neutral position switch circuit

2. Park/neutral position switch

3. TCM

Comes on

DTC stored


P0711

Transmission Fluid Temperature Sensor "A" Performance

ATF temperature sensor

Comes on

DTC stored


P0712

Transmission Fluid Temperature Sensor "A" Circuit Low Input

1. Short in ATF temperature sensor circuit

2. Transmission wire

3. ATF temperature sensor

4. TCM

Comes on

DTC stored


P0713

Transmission Fluid Temperature Sensor "A" Circuit High Input

1. Open in ATF temperature sensor circuit

2. Transmission wire

3. ATF temperature sensor

4. TCM

Comes on

DTC stored


P0715

Input / Turbine Speed Sensor Circuit Malfunction

1. Transmission revolution sensor (speed sensor NT)

2. Transmission wire

3. TCM

Comes on

DTC stored


P0717

Input Speed Sensor Circuit No Signal

1. Transmission revolution sensor (speed sensor NT)

2. Transmission wire

3. TCM

Comes on

DTC stored


P0724

Brake Switch "B" Circuit High

1. Short in stop light switch signal circuit

2. Stop light switch

3. TCM

Comes on

DTC stored


P0741

Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL)

1. Shift solenoid valve SL remains closed

2. Valve body is blocked

3. Torque converter assembly

4. Automatic transaxle (clutch, brake or gear etc.)

5. Line pressure is too low

Comes on

DTC stored


P0746

Pressure Control Solenoid "A" Performance (Shift Solenoid Valve SL1)

1. Shift solenoid valve SL1 remains open or closed

2. Valve body is blocked

3. Automatic transaxle (clutch, brake or gear etc.)

Comes on

DTC stored


P0748

Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1)

1. Open or short in shift solenoid valve SL1 circuit

2. Shift solenoid valve SL1

3. TCM

Comes on

DTC stored


P0776

Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2)

1. Shift solenoid valve SL2 remains open or closed

2. Valve body is blocked

3. Automatic transaxle (clutch, brake or gear etc.)

Comes on

DTC stored


P0778

Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2)

1. Open or short in shift solenoid valve SL2 circuit

2. Shift solenoid valve SL2

3. TCM

Comes on

DTC stored


P0791

Intermediate Shaft Speed Sensor "A" Circuit

1. Transmission revolution sensor (speed sensor NC)

2. Transmission wire

3. TCM

Comes on

DTC stored


P0793

Intermediate Shaft Speed Sensor "A"

1. Transmission revolution sensor (speed sensor NC)

2. Transmission wire

3. TCM

Comes on

DTC stored


P0796

Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3)

1. Shift solenoid valve SL3 remains open or closed

2. Valve body is blocked

3. Automatic transaxle (clutch, brake or gear etc.)

Comes on

DTC stored


P0798

Pressure Control Solenoid "C" Electrical (Shift Solenoid Valve SL3)

1. Open or short in shift solenoid valve SL3 circuit

2. Shift solenoid valve SL3

3. TCM

Comes on

DTC stored


P0989

Transmission Fluid Pressure Sensor / Switch "E" Circuit Low

1. ATF temperature sensor assembly (ATF pressure switch No. 3)

2. Transmission wire

3. TCM

Comes on

DTC stored


P0990

Transmission Fluid Pressure Sensor / Switch "E" Circuit High

1. ATF temperature sensor assembly (ATF pressure switch No. 3)

2. Transmission wire

3. TCM

Comes on

DTC stored


P2714

Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)

1. Shift solenoid valve SLT remains open

2. Shift solenoid valve SL1, SL2, SL3 or SL4 remains open or closed

3. Valve body is blocked

4. Automatic transaxle (clutch, brake or gear, etc.)

Comes on

DTC stored


P2716

Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)

1. Open or short in shift solenoid valve SLT circuit

2. Shift solenoid valve SLT

3. TCM

Comes on

DTC stored


P2757

Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU)

1. Shift solenoid valve SLU remains open or closed

2. Valve body is blocked

3. Torque converter assembly

4. Automatic transaxle (clutch, brake or gear, etc.)

5. Line pressure is too low

Comes on

DTC stored


P2759

Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU)

1. Open or short in shift solenoid valve SLU circuit

2. Shift solenoid valve SLU

3. TCM

Comes on

DTC stored


P2769

Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)

1. Short in shift solenoid valve SL circuit

2. Shift solenoid valve SL

3. TCM

Comes on

DTC stored


P2770

Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)

1. Open in shift solenoid valve SL circuit

2. Shift solenoid valve SL

3. TCM

Comes on

DTC stored


P2808

Pressure Control Solenoid "G" Performance (Shift Solenoid Valve SL4)

1. Shift solenoid valve SL4 remains open or closed

2. Valve body is blocked

3. Automatic transaxle (clutch, brake or gear etc.)

Comes on

DTC stored


P2810

Pressure Control Solenoid "G" Electrical (Shift Solenoid Valve SL4)

1. Open or short in shift solenoid valve SL4 circuit

2. Shift solenoid valve SL4

3. TCM

Comes on

DTC stored


U0100

Lost Communication with ECM / PCM "A"

1. Harness and connector

2. ECM

3. TCM

Comes on

DTC stored


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) (P2769,P2770)
DESCRIPTION Shift solenoid valve SL is turned on and off by signals from the TCM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up ...

Other materials about Toyota Venza:

Engine coolant
The coolant level is satisfactory if it is between the “F” and “L” lines on the reservoir when the engine is cold. 1. Reservoir cap 2. Full 3. Low If the level is on or below the “L” line, add coolant up to the “F” line.  - If the ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful bec ...

TRAC OFF Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN communication. WIRING DIAGRAM Refer to TRAC OFF Indicator Light Remains ON (See page ). PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Check ...

© 2016-2024 Copyright www.tovenza.com

0.1747