Toyota Venza: Airbag System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Check Mode Procedure
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Passenger Airbag ON/OFF Indicator Circuit Malfunction (B1660/43)
- Door Side Airbag Sensor RH Malfunction (B1690/15)
- Door Side Airbag Sensor LH Malfunction (B1695/16)
- Short in Driver Side Squib Circuit (B1800/51-B1803/51)
- Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
- Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
- Short in Front Passenger Side Squib 2nd Step Circuit (B1815/54-B1818/54)
- Short in Passenger Side Airbag Variable Vent Hole Squib Circuit (B181A/7A-B181D/7A)
- Short in Side Squib RH Circuit (B1820/55-B1823/55)
- Short in Side Squib LH Circuit (B1825/56-B1828/56)
- Short in Curtain Shield Squib RH Circuit (B1830/57-B1833/57)
- Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
- Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
- Short in Front Pretensioner Squib RH Circuit (B1900/73-B1903/73)
- Short in Front Pretensioner Squib LH Circuit (B1905/74-B1908/74)
- Seat Belt Buckle Switch LH Circuit Malfunction (B1656/38)
- Seat Position Airbag Sensor Circuit Malfunction (B1653/35)
- Occupant Classification System Malfunction (B1650/32)
- Lost Communication with Rear Airbag Sensor LH (B1637/82,B1638/82,B1647/82,B1697/82,B1698/82)
- Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
- Lost Communication with Rear Airbag Sensor RH (B1632/81,B1633/81,B1642/81,B1692/81,B1693/81)
- Rear Airbag Sensor RH Circuit Malfunction (B1630/23)
- Lost Communication with Front Satellite Sensor Bus (B161A/8A)
- Lost Communication with Front Airbag Sensor LH (B1617/84,B1618/84)
- Front Airbag Sensor LH Malfunction (B1615/14)
- Center Airbag Sensor Assembly Malfunction (B1000/31)
- Lost Communication with Front Airbag Sensor RH (B1612/83,B1613/83)
- Front Airbag Sensor RH Malfunction (B1610/13)
- SRS Warning Light Remains ON
- SRS Warning Light does not Come ON
- TC and CG Terminal Circuit
Precaution
PRECAUTION
HINT:
In the airbag system, the front airbag sensor, door side airbag sensor
and rear airbag sensor are collectively referred to as the airbag sensors.
The steering pad ...
Other materials about Toyota Venza:
MIL Circuit
DESCRIPTION
The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions
detected by the ECM. By turning the ignition switch to ON, power is supplied to
the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
...
Power Mirror cannot be Adjusted with Power Mirror Switch
SYSTEM DESCRIPTION
The main body ECU (driver side junction block assembly) detects the mirror adjust
switch status and sends the signal to the outer mirror control ECU assembly via
CAN communication. On receiving the signal, each outer mirror control ECU ...
Data Signal Circuit between Navigation Receiver Assembly and Extension Module
DESCRIPTION
The stereo component tuner assembly sends the image data signal to the navigation
receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
1.
CHECK NAVIGATION WIRE
(a) Remove the navigation wire (See pag ...
0.1142