Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Back Door / DTC.

HINT:

Refer to the Techstream operator's manual for further details.

(e) Check DTCs and then write them down.

(f) Confirm the details of the DTCs (See page ).


2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Back Door / DTC / Clear.

HINT:

Refer to the Techstream operator's manual for further details.

(e) Clear the DTCs by following the directions on the Techstream screen.

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The power back door ECU (power back door motor unit)*1 or back door closer ECU (multiplex network door ECU)*2 controls the vehicle's back door closer system ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FUEL SENDER GAUGE 2. SEPARATE FUEL SUCTION PLATE SUB-ASSEMBLY (a) Disconnect the fuel pump connector from the fuel suction plate. NOTICE: Do not damage the wire harness. ...

Rear Spoiler
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE UPPER BACK WINDOW PANEL TRIM 2. REMOVE REAR SPOILER ASSEMBLY (a) Disconnect the connector. (b) Remove the 2 hole ...

Diagnosis System
DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. FUNCTION OF P/S WARNING LIGHT (a) When a malfunction is detected in the power steering system, the P/S warning light on the accessory meter comes on to inform the driver of the malfunctio ...

© 2016-2026 Copyright www.tovenza.com

0.1558