Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Read the DTCs by following the directions on the Techstream screen.

HINT:

Refer to the Techstream operator's manual for further details.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Clear the DTCs by following the directions on the Techstream screen.

HINT:

Refer to the Techstream operator's manual for further details.

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) (a) Disconnect the L20 ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table be ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Unlock Position Sensor Signal Circuit
DESCRIPTION The unlock position sensor is one of the components comprising the steering lock ECU (steering lock actuator assembly). The sensor switch contact closes when the steering lock is released. The steering lock release signal is then sent to the ...

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use high-temperature grease to lubricate the bearings, gears and return spring when assembling the starter. PROCEDURE 1. INSTALL PLANETARY GEAR (a) Apply grease to the planetary gears and pin parts of ...

IG2 Signal Malfunction (B2788)
DESCRIPTION The steering lock ECU (steering lock actuator assembly) receives power from the IG2 relay. When the voltage value indicated by the IG signal from the certification ECU (smart key ECU assembly) equals to the voltage that is applied to the steer ...

© 2016-2026 Copyright www.tovenza.com

0.1549