Toyota Venza manuals

Toyota Venza: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key. Main Body or Power Source Control / Trouble Codes.

(e) Check the details of the DTC(s) (See page ).


2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key. Main Body or Power Source Control / Trouble Codes.

(e) Clear the DTC(s).

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The main body ECU (driver side junction block assembly) and certification ECU (smart key ECU assembly) control the LIN communication system. LIN communication sys ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Other materials about Toyota Venza:

Follow the correction procedures. (smart key system)
After taking the specified steps to correct the suspected problem, check that the warning light turns off.  - If the malfunction indicator lamp comes on while driving First check the following: • Is the fuel empty? If it is, fill the fuel tan ...

Fuel Pump Control Circuit
DESCRIPTION 1. w/o Smart Key System When the engine is cranked, the starter relay drive signal output from the ignition switch is input into the STA terminal of the ECM, and the NE signal generated by the crankshaft position sensor is also input into the ...

Front Wiper Rubber
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE FRONT WIPER BLADE (a) Remove the holder of the front wiper blade. (b) Remove the front wiper blade from the f ...

© 2016-2026 Copyright www.tovenza.com

0.1466