Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

If a trouble code is displayed during the DTC check, check the trouble areas listed for that code in the table below and proceed to the appropriate page.

Cruise Control System

DTC Code

Detection Item

Trouble Area

See page

P0500

Vehicle Speed Sensor Malfunction

- Vehicle speed sensor signal circuit

- Vehicle speed sensors

- Combination meter assembly

- ECM


P0503

Vehicle Speed Sensor "A" Intermittent / Erratic / High

- Vehicle speed sensors

- Vehicle speed sensor signal circuit

- Combination meter assembly

- ECM


P0571

Brake Switch "A" Circuit

- Stop light switch assembly

- Stop light switch circuit

- ECM


P0575

Cruise Control Input Circuit

ECM


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Vehicle Speed Sensor "A" Intermittent / Erratic / High (P0503)
DESCRIPTION If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while the cruise control is in operation, the ECM det ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. INSTALL TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System) 2. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY 3. INSTALL NO. 1 BACK DOOR EMBLEM 4. INSTALL NO. 2 BACK DOOR NAME PLATE 5. INSTALL BACK DOOR OUTSIDE GARNIS ...

CD cannot be Inserted / Played or CD is Ejected Right After Insertion
PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective. OK: CD is nor ...

Ignition Switch Circuit
DESCRIPTION The main body ECU (driver side junction block assembly) determines the ignition switch position (OFF, ACC, ON) based on signals from the IG or ACC circuit. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM ...

© 2016-2026 Copyright www.tovenza.com

0.127