Toyota Venza: Data List / Active Test

Toyota Venza Service Manual / Theft Deterrent / Keyless Entry / Theft Deterrent System(w/o Smart Key System) / Data List / Active Test

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) According to the display on the Techstream, read the Data List.

Main Body

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Key Unlock Warning SW	Unlock warning switch signal/ON or OFF	ON: Key inserted in the ignition key cylinder OFF: Key removed from the ignition key cylinder	-
ACC SW	Ignition switch ACC signal/ON or OFF	ON: Ignition switch ACC OFF: Ignition switch off	-
IG SW	Ignition switch signal/ON or OFF	ON: Ignition switch ON OFF: Ignition switch off	-
D Door Courtesy SW	D door courtesy switch/ON or OFF	ON: Driver side door open OFF: Driver side door closed	-
P Door Courtesy SW	P door courtesy switch/ON or OFF	ON: Front passenger side door open OFF: Front passenger side door closed	-
RR Door Courtesy SW	Rear right door courtesy switch/ON or OFF	ON: Rear right door open OFF: Rear right door closed	-
RL Door Courtesy SW	Rear left door courtesy switch/ON or OFF	ON: Rear left door open OFF: Rear left door closed	-
Back Door Courtesy SW	Back door courtesy switch/ON or OFF	ON: Back door open OFF: Back door closed	-
D-Door Lock Pos SW	Driver's door lock position switch/ON or OFF	ON: Driver door unlocked OFF: Driver door locked	-
P-Door Lock Pos SW	Passenger door lock position switch/ON or OFF	ON: Passenger door unlocked OFF: Passenger door locked	-
Back Door Open	Back door lock / Permit or Prohibit	Permit: Back door unlocked Prohibit: Back door locked	-
RR-Door Lock Pos SW	Rear right door lock position switch/ON or OFF	ON: Rear right door unlocked OFF: Rear right door locked	-
RL-Door Lock Pos SW	Rear left door lock position switch/ON or OFF	ON: Rear left door unlocked OFF: Rear left door locked	-
Passive Mode (Security system)	Passive mode/ON or OFF	ON: Passive mode on OFF: Passive mode off	-
Warning by Horn	Warning by horn/ON or OFF	ON: Vehicle horns sound during alarm sounding state OFF: Vehicle horns do not sound during alarm sounding state	-
Entry Delay	Entry delay time during passive mode	0 s: Entry delay time 0 sec. 14 s: Entry delay time 14 sec. 30 s: Entry delay time 30 sec.	-

2. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(d) Enter the following menus: Body Electrical / Main Body / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Main Body

Tester Display	Test Part	Control Range	Diagnostic Note
Hazard	Hazard warning lights	ON / OFF	-
Vehicle Horn	Vehicle horns	ON / OFF	-
Security Indicator	Security indicator	ON / OFF	-
Security Horn	Security horn	ON / OFF	-

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the main body ECU (driver side junction block assembly) connectors. (b) Measure the resistance and vol ...

Engine Hood Courtesy Switch Circuit

DESCRIPTION The security courtesy switch is installed together with the hood lock. This switch turns off when the engine hood is opened and turns on when the engine hood is closed. WIRING DIAGRAM ...

Other materials about Toyota Venza:

Fail-safe Chart
FAIL-SAFE CHART 1. HID Headlight System (a) Light Control ECU (1) The light control ECU stops illuminating the HID headlights when any of the following abnormalities are detected. Condition Content Open in output si ...

Atf Temperature Sensor(when Using The Engine Support Bridge)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester C ...

Removal
REMOVAL PROCEDURE 1. DISCHARGE FUEL SYSTEM PRESSURE HINT: (See page ). 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 3. REMOV ...