Toyota Venza: Components

Water Pump

...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FOR COOLANT LEAK HINT: The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is d ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL REAR STABILIZER BAR BRACKET LH (for Front Side) (a) Temporarily install the rear stabilizer bar bracket LH (front side) with the bolt. HINT: Loosely tighten the bolt so that the bracket can ...

Steering Angle Sensor Circuit Malfunction (C1231/31)
DESCRIPTION The steering angle sensor signal is sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it will be detected by the steering angle sensor zero point malfunction diagnostic ...

Check Mode Procedure
CHECK MODE PROCEDURE 1. DESCRIPTION (a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are d ...